What parts of the bag making machine system?
Bag making machine cutting system by the cutter, the length of the regulator, beyond the clutch, wire and other parts of the regulation.
1, cutter: the system is the most important components, is the use of moving knife and sliding guide, by the spring compression of the floating mechanism, up and down the knife can be adjusted. Which is equipped with adjustment screw, can be used to adjust the tightness of the cutter, can be a good exclusion of raw materials difficult phenomenon.
2, the bag length regulator: bag length adjustment to change the connecting rod set on the eccentric carriage position to control the length of the bag, by tightening the hand wheel and nut to adjust the bag size.
3, beyond the clutch: the plastic over the clutch is an important part of the machine, its quality, performance directly affect the length of the product error, but in the course of the use of high frequency, bag making machine so its life also has a certain limit. If you find the production process bag length error (generally after six months of continuous production), and exclude other failures still can not be resolved, the clutch can be opened to check, repair.
4, wire and cutting line distance adjustment: the distance between the wire and the cutting line is generally 5-10mm, bag making machine turn the adjustment hand on the hand wheel, so that the beam roll up or down a certain distance, get the ideal cutting line. In order to facilitate the observation of the quality of the wire, you can put the single-wire wire position to the end of the machine cutter. If the wire and the bottom line is not parallel, you can release a bevel gear tightening screw, turn the hand wheel so that one end of the beam roller on the rise or fall; production stability, then the gear screw lock.
5, welding knife adjustment method: in the bearing seat pad with a thin paper, hand rotation of the body of the large handwheel so that the welding knife at the bottom dead center, release the nut, adjust the nut, hand pull the two ends of the paper The degree of compression until it is approximately equal. After adjusting, to lock the nut, to prevent loosening.
6, automatic light control feeding device: The device consists of servo motor, feeding roller, light control apron, blinds, photoelectric tracking machine and electric control line, its function is to maintain the normal production process to send the film. When the machine is running, when the film feed speed is too fast, bag making machine cover the light control ray, the device will issue a command to stop the motor rotation feed.