Bag Making Machine cutting system by the cutter, the length of the regulator, beyond the clutch, wire and other parts of the regulation.
1, cutter: the system is the most important components, is the use of moving knife and sliding guide, by the spring compression of the floating mechanism, up and down the knife can be adjusted. Which is equipped with adjustment screw, can be used to adjust the tightness of the cutter, can be a good way to exclude the difficult phenomenon of raw materials.
2, the bag length regulator: bag length adjustment to change the connecting rod set on the eccentric carriage position to control the bag length, by tightening the hand wheel and nut to adjust the bag size.
3, beyond the clutch: the plastic over the clutch is an important part of the machine, its quality, performance directly affect the length of the product error, bag making machine but in the course of the use of high frequency, so its life also has a certain limit. If you find the production process bag length error (generally after six months of continuous production), and exclude other failures still can not be resolved, the clutch can be opened to check, repair.
4, wire and cutting line distance adjustment: the distance between the wire and the cutting line is generally 5-10mm, turn the handlebar on the hand wheel, so that the beam roll up or down a certain distance, get the ideal cutting line. In order to facilitate the observation of the quality of the wire, you can put the single-wire wire position to the end of the machine cutter. If the wire and the bottom line are not parallel, bag making machine you can release a bevel gear tightening screw, turn the hand wheel so that one end of the beam roller on the rise or fall; production stability, then the gear screw lock.
5, welding knife adjustment method: in the bearing seat on a pad of thin paper, hand rotation of the body of the large handwheel so that the welding knife at the bottom dead center, loosen the nut, adjust the nut, hand pull the two ends of the paper The degree of compression until it is approximately equal. After adjusting, to lock the nut to prevent loosening.
6, automatic light control feeding device: The device consists of servo motor, feeding roller, light control apron, blinds, photoelectric tracking machine and electric control line, bag making machine its function is to maintain the normal production process to send film. When the machine is running, when the film feed speed is too fast, cover the light control ray, the device will issue a command to stop the motor rotation feed.