Film blowing machine heating transformation step
1.to remove converted part of the barrel of the original heater.
2. a good amount of barrel size, typically including perimeter length, calculate therequired heat preservation cotton and power estimation of heating coil winding according to original location is enough.
3. wrap insulation cotton in the barrel, used bandages tied tightly, keep the thickness of heat preservation cotton at about 1.5-2.0CM, in order to make the installation more artistic, on heat preservation cotton and wrapped in a layer of insulating resin plate 0.5mm.
4. above the wrap barrel wrapped magnet wire, magnet wire wound should be asclose as possible.5. install electromagnetic heating control cabinets.