Printing machine in the course of the use of regular problems, often damage the parts, electrical problems occur frequently, it was said that the machine is too old. Although the old machine is an objective reason, but the new machine will not fail? Some printing machine new machine failure more than the old machine. Objectively speaking, the use of the machine and failure rate, including the following factors: the quality of the machine manufacturing, installation commissioning, maintenance, reasonable operation, the most important is the quality of maintenance. The quality of the machine is the objective existence of the factory, whether it is new or old machine, installed and commissioned is the first off.
General new machines in the factory are installed and debugged, after quality inspection, and then after the packaging of the packaging. Not just the level and the reasonable installation problem, there is a check and correct the problem. Old machine should be so, as for maintenance, use is not to say, just want to talk about maintenance quality:
Maintenance is not a simple disassembly, not only to find the cause of the failure, but also to find other problems with the incident.
The press has a strict time with the relationship, and assembly tolerances and adjustment values, busy demolition and over-regulation is the main reason for the machine to accelerate wear and failure again.
Spare parts procurement and processing quality, not necessarily any parts and electrical components to use the original parts, the original parts of the high cost of purchase cycle, unless the special or key spare parts, other parts of most parts and electrical components can be used , As long as the parts processing technology and components to understand the characteristics.
Circuit failure in addition to the natural damage to the machine, the main disassembly is not carefully derived from the installation of hidden fault or did not find the circuit caused by the failure of the machine and human factors.